02 - HF2PBB HONDA Oxygen Sensor Eliminator

02 - HF2PBB HONDA Oxygen Sensor Eliminator

02 - HM2PB HONDA Oxygen Sensor Eliminator

02 - HM2PB HONDA Oxygen Sensor Eliminator

02 - HF2PB HONDA Oxygen Sensor Eliminator

  Improved throttle response, smoother power delivery.
  Supports FI mods such as Power Commander.
  Cheaper than replacing a faulty o2 sensor.
  Simple to fit, No cutting or soldering required.

CB 600 F HORNET 2007-2015, CBR 600 RR 2007-2012, CBR 600F 2011-2016, XL 700V TRANSALP 2007-2016, CBF 1000 2006-2009, CBR 1000 RR FIREBLADE 2004-2007,

£12.99
Availability: In stock
SKU
02HF2PB-H

The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations.

The intention behind it is not to improve the performance of the machine.

It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.

600

CB 600 F HORNET

2007-2015

02 - HF2PB

1

M18 x 1.5mm

600

CBR 600 RR                    

2007-2012

02 - HF2PB

1

M18 x 1.5mm

600

CBR 600F

2011-2016

02 - HF2PB

1

M18 x 1.5mm

700

XL 700V TRANSALP

2007-2016

02 - HF2PB

1

M18 x 1.5mm

1000

CBF 1000 

2006-2009

02 - HF2PB

1

M18 x 1.5mm

1000

CBR 1000 RR FIREBLADE

2004-2007

02 - HF2PB

1

M18 x 1.5mm

We always recommend removing your o2 sensor and fitting a blanking plug as a non heated o2 sensor can become damaged.