02 - SF2PB SUZUKI Oxygen Sensor Eliminator

02 - SF2PB SUZUKI Oxygen Sensor Eliminator

02 - HF2PB SUZUKI Oxygen Sensor Eliminator Set

02 - HF2PB SUZUKI Oxygen Sensor Eliminator Set

02 - HF2PB SUZUKI Oxygen Sensor Eliminator

  Improved throttle response, smoother power delivery.
  Supports FI mods such as Power Commander.
  Cheaper than replacing a faulty o2 sensor.
  Simple to fit, No cutting or soldering required.

BURGMAN 400 2003-2017, GSR 600 2005-2010, GSXR 600 K5-L0 2005-2010, BURGMAN 650 2003-2012, DL 650 V-STROM 2004-2011, GSXR 750 K6-K7 2006-2007, SV 1000 2003-2007, GSX 1300R HAYABUSA 2000-2007,

£12.99
Availability: In stock
SKU
02HF2PB-S

The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations.

The intention behind it is not to improve the performance of the machine.

It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.

400

BURGMAN 400                       

2003-2017

02 - HF2PB

1

M18 x 1.5mm

600

GSR 600

2005-2010

02 - HF2PB

1

M18 x 1.5mm

600

GSXR 600 K5-L0                  

2005-2010

02 - HF2PB

1

M18 x 1.5mm

650

BURGMAN 650

2003-2012

02 - HF2PB

1

M18 x 1.5mm

650

DL 650 V-STROM

2004-2011

02 - HF2PB

1

M18 x 1.5mm

750

GSXR 750 K6-K7

2006-2007

02 - HF2PB

1

M18 x 1.5mm

1000

SV 1000

2003-2007

02 - HF2PB

1

M18 x 1.5mm

1300

GSX 1300R HAYABUSA

2000-2007

02 - HF2PB

1

M18 x 1.5mm

We always recommend removing your o2 sensor and fitting a blanking plug as a non heated o2 sensor can become damaged.