02 - HF2PB HONDA Oxygen Sensor Eliminator

02 - HF2PB HONDA Oxygen Sensor Eliminator

VT750 S / RS SHADOW 10 - 14 o2 Oxygen Sensor Eliminator

VT750 S / RS SHADOW 10 - 14 o2 Oxygen Sensor Eliminator

02 - HM2PB HONDA Oxygen Sensor Eliminator

  Improved throttle response, smoother power delivery.
  Supports FI mods such as Power Commander.
  Cheaper than replacing a faulty o2 sensor.
  Simple to fit, No cutting or soldering required.

RUCKUS/ZOOMER 2002-2017, CBF 600 2008-2015, DN-01 2008-2010, NT 700 V DEAUVILLE 2006-2015, VTR 1000 SP1 SP2 2000-2006, XLV 1000 VARADERO 2003-2013,

CBR 600 F4i 2001-2007, CBR 929 FIREBLADE 2000-2001, CBR 954 FIREBLADE 2002-2003, VTX 1800 C 2002-2008

£12.99
Availability: In stock
SKU
02HM2PB

The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations.

The intention behind it is not to improve the performance of the machine.

It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.

50

RUCKUS/ZOOMER

2002-2017

02 - HM2PB

1

M18 x 1.5mm

600

CBF 600

2008-2015

02 - HM2PB

1

M18 x 1.5mm

700

DN-01

2008-2010

02 - HM2PB

1

M18 x 1.5mm

700

NT 700 V DEAUVILLE

2006-2015

02 - HM2PB

1

M18 x 1.5mm

1000

VTR 1000 SP1 SP2

2000-2006

02 - HM2PB

1

M18 x 1.5mm

1000

XLV 1000 VARADERO

2003-2013

02 - HM2PB

1

M18 x 1.5mm

 

 

600

CBR 600 F4i

2001-2007

02 - HM2PB

1

M12 x 1.25mm

1000

CBR 929 FIREBLADE

2000-2001

02 - HM2PB

1

M12 x 1.25mm

1000

CBR 954 FIREBLADE

2002-2003

02 - HM2PB

1

M12 x 1.25mm

1800

VTX 1800 C

2002-2008

02 - HM2PB

1

M12 x 1.25mm

We always recommend removing your o2 sensor and fitting a blanking plug as a non heated o2 sensor can become damaged.