02 - KF2PT KAWASAKI Oxygen Sensor Eliminator

02 - KF2PT KAWASAKI Oxygen Sensor Eliminator

02 - KM4P KAWASAKI Oxygen Sensor Eliminator set

02 - KM4P KAWASAKI Oxygen Sensor Eliminator set

02 - KM4P KAWASAKI Oxygen Sensor Eliminator

  Improved throttle response, smoother power delivery.
  Supports FI mods such as Power Commander.
  Cheaper than replacing a faulty o2 sensor.
  Simple to fit, No cutting or soldering required.

KLX 125 Efi 2010-2018, Z 125 - NINJA 125 2018-2020, KLX 250 S/SF Efi 2009-2020, NINJA 250 2014-2016, Z 250 2015-2018, 600 ZX6R/636 2009-2020, 800 W 800 2011-2016, 1000 ZX10-R 2011-2020, 1400 ZZR 1400 2006-2020,

£12.99
Availability: In stock
SKU
O2KM4P

The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations.

The intention behind it is not to improve the performance of the machine.

It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.

125

KLX 125 Efi

2010-2018

02 - KM4P

1

M12 x 1.25mm

125

Z 125 - NINJA 125

2018-2020

02 - KM4P

1

M12 x 1.25mm

250

KLX 250 S/SF Efi

2009-2020

02 - KM4P

1

M12 x 1.25mm

250

NINJA 250

2014-2016

02 - KM4P

1

M12 x 1.25mm

250

Z 250

2015-2018

02 - KM4P

1

M12 x 1.25mm

600

ZX6R/636

2009-2020

02 - KM4P

1

M12 x 1.25mm

800

W 800

2011-2016

02 - KM4P

1

M12 x 1.25mm

1000

ZX10-R

2011-2020

02 - KM4P

1

M12 x 1.25mm

1400

ZZR 1400

2006-2020

02 - KM4P

1

M12 x 1.25mm

We always recommend removing your o2 sensor and fitting a blanking plug as a non heated o2 sensor can become damaged.