02 - KTYF4P KTM Oxygen Sensor Eliminator

02 - KTYF4P KTM Oxygen Sensor Eliminator

02 - KTYF4P KTM Oxygen Sensor Eliminator Set

  Improved throttle response, smoother power delivery.
  Supports FI mods such as Power Commander.
  Cheaper than replacing a faulty o2 sensor.
  Simple to fit, No cutting or soldering required.

1190 ADVENTURE 2013-2016, 1090 ADVENTURE 2017-2019, 1050 ADVENTURE 2015-2020, 1290 SUPER DUKE 2014-2020, 1290 SUPER ADVENTURER 2015-2020,

£23.99
Availability: In stock
SKU
02KTYF4P-KT-SET

The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations.

The intention behind it is not to improve the performance of the machine.

It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.

1190

1190 ADVENTURE

2013-2016

02 - KTYF4P

2

M12 X 1.25mm

1090

1090 ADVENTURE

2017-2019

02 - KTYF4P

2

M12 X 1.25mm

1050

1050 ADVENTURE

2015-2020

02 - KTYF4P

2

M12 X 1.25mm

1290

1290 SUPER DUKE

2014-2020

02 - KTYF4P

2

M12 X 1.25mm

1290

1290 SUPER ADVENTURER

2015-2020

02 - KTYF4P

2

M12 X 1.25mm

We always recommend removing your o2 sensor and fitting a blanking plug as a non heated o2 sensor can become damaged.