02 - YF4P ENFIELD Oxygen Sensor Eliminator

  Improved throttle response, smoother power delivery.
  Supports FI mods such as Power Commander.
  Cheaper than replacing a faulty o2 sensor.
  Simple to fit, No cutting or soldering required.

CLASSIC 500 C5 EFI 2012-2017, BULLET 500 EFI 2009-2020, THUNDERBIRD 500 EFI 2012-2017, CONTINENTAL GT 535 2014-2017, INTERCEPTOR 650 FI 2018-2020, CONTINENTAL GT 650 2018-2020, HIMALAYAN 2018-2020,

£12.99
Availability: In stock
SKU
02YF4P-E

The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations.

The intention behind it is not to improve the performance of the machine.

It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.

500

CLASSIC 500 C5 EFI                  

2012-2017

02 - YF4P

1

M12 x 1.25mm

500

BULLET 500  EFI                          

2009-2020

02 - YF4P

1

M12 x 1.25mm

500

THUNDERBIRD 500 EFI              

2012-2017

02 - YF4P

1

M12 x 1.25mm

535

CONTINENTAL GT 535                

2014-2017

02 - YF4P

1

M12 x 1.25mm

650

INTERCEPTOR 650 FI

2018-2020

02 - YF4P

1

M12 x 1.25mm

650

CONTINENTAL GT 650                

2018-2020

02 - YF4P

1

M12 x 1.25mm

 

HIMALAYAN

2018-2020

02 - YF4P

1

M12 x 1.25mm

We always recommend removing your o2 sensor and fitting a blanking plug as a non heated o2 sensor can become damaged.